Subject: drilling screw holes in oil pan.
From: rotaryeng
Date: 6/13/2013, 5:42 AM
To: AAA-rotaryeng


By now all you guys have your oil pans or will have them shortly.
Be careful about drilling the holes. It is easy to screw up.
Get some transparent lexan from home depot and make a template of your steel pan if you have one or the bottom of your  engine.

There are several different hole patterns and they are not symmetrical from side to side so mark your template top and bottom.

Transfer punches are great but they cost a lot and you don't find them at home depot.

So carefully use a center punch in the middle of the hole with the lexan clamped to the steel pan. You can also drill two
wide spaced holes and temporarily bolt the lexan to the engine.

The pressure regulator on the 13B  sticks down below the top plate of the pan so make sure it clears the pan wall while the near by holes are as far from the pan wall as possible.

The pressure regulator on the RX8 is above the top part
of the pan so it is no problem.

To get the best clamping pressure on the pan bolts buy some 1/2 inch wide 1/4 thick steel bar from home depot. Buy new longer metric socket head screws from Mac Master carr. Match drill the holes. Use the steel bar under the bolt head of the screws. Steel is 3 times stiffer than aluminum so the pressure between screws is more uniform. Your more likely to get a leak free joint the first time. If you object to the weight of the steel  home depot also has extruded aluminum channel about a 1/2 wide by a 1/2 high. The socket head metric screws will fit in there fine. Better than nothing. If we made the flange any thicker it would be impossible to weld on my 175 amp welder.


BTW the need for a an air oil separator plate is an urban myth.
The pan is lighter with out it. By the time the cooling oil out of the rotors gets to the oil pan it must go through several passages in the center housing. That is left over thinking from crank shaft days.

Paul Lamar

Just a note, transfer punch sets can be had very reasonably from harbor freight, and or do an internet search. Many tool warehouses have them for prices that the shipping will rival the product cost.
C. Smith


-- 
The Rotary Engine News Letter. Powered by Linux. ACRE NL web
site. http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas Copyright 1998-2013 All world wide
rights reserved.