I counted the teeth of the gear reduction in the DD15
gear box. The turbine gear had 22 teeth and the big gear
had 107 teeth. That is a gear reduction of 4.86:1.
That means at 40,000 turbine RPM (the reputed operating RPM of the
DD15 power recovery turbine) the out rotates at 8,230 RPM.
PERFECT FOR THE ROTARY!!!!!!!!!!!
Looking into the huge exhaust port of the turbine the turbine is
rotating clockwise. Looking at the output shaft of the TC gear
box it is rotating counter clockwise.
Looking at the rotary from the bell housing end the rotary
e-shaft also rotates counter counter clockwise. The exhaust and
intake on the right.
IT COULD NOT BE BETTER IF THE DD15 TURBO COMPOUND SYSTEM
HAD BEEN DESIGNED FOR THE ROTARY!!!!!!!!!
All we now need is a simple shaft coupling. shown in the
3D as a black cylinder. No cog belt drive lash up necessary.
This would make a great boat engine. A turbo charged P-port 3
rotor followed with a DD15 turbo compound system.
1000 HP at a BSFC in the diesel range. Below .4 !!!!!!!
20,000 hour life with all ceramic seals.
1000 to 1500 pounds less weight than a diesel with about
the same fuel burn.
Paul Lamar
Paul,
I am rebuilding my "91" RX-7. When can I start bolting it up???
I also need a good source for all the seals and gaskets.
Porting options available? Just looking for better the stock for my baby.
Thomas
Your joking of course :) It weighs almost as much as 2 rotor.
Check out Creavy O-rings for Teflon encapsulated silicone O-rings.
http://www.creavey.com/
Use stock Mazda apex seals from Mazdatrix. After market seals
tear up you rotor housing wear surfaces.
http://www.rotaryeng.net/seals.html
http://www.rotaryeng.net/history.html
http://www.rotaryeng.net/O-ring-size2.html
Paul Lamar