Subject: Mark's torsional damper kit is ready to ship
From: rotaryeng
Date: 6/19/2013, 5:25 PM
To: AAA-rotaryeng


Craig, $200 for the kit. Some of the parts were hard
to cut and I must tack weld some of it to true it
up on the lathe. Spline plate not included.
That is a separate deal if you want a new one cut down.
Of course you can use the one that came with the gear box.

More labor than I expected.

$300 if you want my ace tig welder to do it.
(Argon is now $90 a tank.)

Paul

   Paul should the open ends of the rect tubes be caped
( to make more rigid )...........?

Kelly Troyer

Not necessary but would not hurt.

Paul Lamar

-- 
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.