I have been reading about a psru developed for the R1200 bmw
motorcycle engine that is used in aircraft tractor and trike pusher
configuration. It uses a centrifugal clutch like ones in most
chainsaws only much larger, this has solved the torsional dampening
problem. The engines are rated 100-115hp continuous 6300 rpm. The
clutch eengauges at 1800 - 2000 rpm and has to be changed every 400
hrs. These engines have run 2000 hrs in this configuration. They
initially had flywheel cracks when they used light ones, beefed them
up cracks stopped engine ran smoother.
Has anyone considered the rubber coupling used to couple a high hp.
electric motor to air compressors and pumps ect. If i understand
there operation correctly they will absorb energy transmitted back to
the motor and shaft miss alignment between motor and equipment. I
have seen these couplings with several thousand hrs. on them with no
visible wear. Steve Hudson
How high is the HP?
Paul Lamar
I have used these couplings and have 10's of hours on the ground
with good results.
chris smale
Do you have a dwg? It must fit in a cylinder six inches in dia. and
1.7 inches long. If it is only rubber the failure would be
catastrophic.
If the rubber fails in mine it only increases the back lash. The
final is metal to metal.
Paul Lamar
The rubber inserts are approx. 1 1/4" in thickness for a 200hp
electric motor,they are similar to the ones in the attachment. Steve
Hudson
Which size and type do you recommend and what are the dimensions? We
have a length of only 1.7 inches to work with. It is not enough to
suggest something one thinks might work. One must do one's
engineering home work. An electric motor is not an internal
combustion engine. 200 HP AC electric motors do not rotate at 8000
RPM.
Finally as I have mentioned several times before since we are making
our own rubber couplings we can control the effective durometer over
a wide range.
I have not spent a lot of time reading all their catalogs. If you
have please let me know the part number.
Paul Lamar --
JM2 German manufactured rubber couplings are used on electric motors
running up to 12000 rpm
Think it is possible to cut off the shaft flange and used bolts to
fit to the spline plate
Le Roux Breytenbach Terason (Pty) Ltd - Rawsonville
"In the future when one is trying to be helpful think of the space
and weight of what one is suggesting. Get a dwg. of the device and
see if it will fit in a 6 inch dia. cyl. and 1.7 inches long. The
devil is always in the details. "
What is it about engineering and dimensions I am not being perfectly
clear about?
Before one sends something in do one's engineering home work and scale
dwgs.
Paul Lamar