Subject: slide throttle 2 barrel side draft carb
From: rotaryeng
Date: 7/7/2013, 11:30 PM
To: AAA-rotaryeng

This can be made with a hack saw a drill press and a file.
It made from a chunk of 1/2 inch thick aluminum plate.

It uses an off the shelf Holly float bowl and an after market "leaning
block." I simplified it from an earlier design.

Uses our p-port slide throttle.

I am going to use a trick Ellison invented. He fed dynamic pressure from a small pito tube in the intake runner to the float bowl chamber. This richen's the mixture automatically at WOT. Dynamic pressure is proportional to runner velocity squared.

Not shown in the 3D.

There is no acceleration pump. So move the throttle slowly.

Set full rich for start and lean for best power before takeoff.

Paul Lamar


-- 
The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.