Subject: slide throttle 2 barrel side draft carb
From: rotaryeng
Date: 7/8/2013, 2:52 PM
To: AAA-rotaryeng


 This can be made with a hack saw a drill press and a file.
 It made from a chunk of 1/2 inch thick aluminum plate.

 It uses an off the shelf Holly float bowl and an after market "leaning
 block." I simplified it from an earlier design.

 Uses our p-port slide throttle.

 I am going to use a trick Ellison invented. He fed dynamic pressure from a
 small pito tube in the intake runner to the float bowl chamber. This
 richen's the mixture automatically at WOT. Dynamic pressure is
proportional
 to runner velocity squared.

 Not shown in the 3D.

 There is no acceleration pump. So move the throttle slowly.

 Set full rich for start and lean for best power before takeoff.

 Paul Lamar

Don't forget to put a heat shield / catch tray under the float bowl.
Holly's are notorious for leaking fuel and the hot exhaust is just inches
away from the bowl.  Just say'in...

Mark S.

OK

Paul

Do you have photos?
Capt. William Little

Not yet.

Soon. After I get the Turbo compound running.

The slide throttle it self is done and flying.

Paul Lamar

--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.