Subject: 3.17 drive Bell housing design for Milo
From: rotaryeng
Date: 7/11/2013, 1:36 AM
To: AAA-rotaryeng



Are all automatic transmission bellinghousings the same?

Will they fit all engines?

Where does the starter fit on an RX8 bellhousing?

Can anyone direct me to a dimensioned drawing for the bellhousing on
 an RX8
engine?

Does anyone have an RX8 automatic transmission bellhousing they wish to
part
with?

Thanks, Milo



 I have a bell from an 81 rx, and a bell from an 89 rx. Both fit on my
 rx8 engine. The early bell is about 2" shorter.
 Whatever bell you use, you should get the starter, and flexplate
 designed for that bell. I purchase rx auto trans bells, with flexplate
 and starter, every time I see one in the yard.

 You will be good with an earlier rx bell. I would have gotten an rx8
 bell if I could have gotten a yard to sell me one for a reasonable
 price, they would not do it, foolishly claimed they had to sell them
 with the trans.

 I believe the bell for the 89 rx is the same up to 2001 rx7, so far as
 it's length goes.
 Correct me if I am wrong.
 There appears to be very few 93 up rx7 parts available, due to the high
 value of this era car.

 I want to buy a 93-95 rx, so I monitor the prices. If I would have known
 how good these cars are back when I purchased my first 944 turbo in 94,
 I would have bought the rx instead.

 Ed Carver


 ED. Thanks for the input. Milo

Hi Milo
This is what I have regarding the bell housing dimensions,design
with Rheno
Jean
  --
 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net.
 You Tube http://tinyurl.com/beqqxas.
 Copyright 1998-2013 All world wide rights reserved.