Subject: Socket head screws for the new torsional dampler
From: rotaryeng
Date: 7/13/2013, 8:10 AM
To: AAA-rotaryeng




I finally got the right metric screws. They will be in the kit after Mark S gets done testing it with the 3 rotor Lancair ES.

This will allow us to pour liquid silicone rubber in the damper and let it cure before installation using long Allen wrenches.

The head of the screws will be inserting into a pieces of 1/2" ID silicone hose that will remain in the damper.

I will use this damper with the Ross copy gear box.

Paul Lamar

Sure would like to see how this could be up-scaled to use on
the V M14p gearbox....
Marc

If you have one loan it to me and I will see what I can do.
It is set up according to Brad Banks as a 60% reduction.

"This is where the annulus ring [ring-gear] is the primary driver
and the sun gear is fixed (hence the flex plate) The planetary assembly
is tasked with moving the propeller shaft."


So I swapped the whole assembly around and secured the annulus
ring to the flex plate this allowed the sun gear to become the
primary drive input, and the ratio is as near to damn it as 3:1.


There are some height issues to deal with where the planetary
assembly needs to be spaced up by 3-5mm to accommodate the
new annulus ringgear holder ( secured again by circlips) ,but
they are minor engineering problems.

  We are left with some 90mm from thesun gear to the face of
the casting that will attach to the 13b.ill have to see what
im going to do there to support the end of the prop shaft
( not sure of a bush or a bearing)and add a dampener if needed."

There will be some serious redesign involved.
Maybe a new case.

Paul Lamar
--
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.