Looks rather cannon prof.
What is the overall length? Should be kept to 15 inches to fit in
most cowls.
Paul Lamar
For a test item it may yield significant data. If it shows promise we
can always try
lightening it. The drive itself is just under 13 inches.
Milo
That is a nice sun gear spline. Where did you get it and the mating
female part? A bit
overkill for only 300 foot pounds.
Paul Lamar
Paul,
We have enough pieces now to get good measurements, so far no glitches.
Milo
The critical measurement is from the bell housing mounting surface to
the prop flange. If you are using a Mazda bell housing part of the PSRU
must be recessed into the bell housing which I think you are doing.
Is that a Mazda bell housing?
Paul Lamar
Yes it is a Mazda bellhousing, but it is not the one I want to use.
We are still shopping for a RX8 automatic bell housing, if you or
anyone else has one, please lend it to us.
Milo
You should build the box to bolt to Jeff's adapter plate
as that has built in motor mounts. RX8 auto tranny bell housings
are hard to come by and if bought new very very expensive.
Paul Lamar
Paul,Milo,
I was under the impressiom that the 93-95 RX7 and the 90+ Cosmo 13B &
20B auto trans
bell housings are virtually identical to the RX8 auto housings.......
Kelly Troyer
The 93 to 95 RX7 are even more rare than the RX8.
Same goes for the 90+ Cosmo.
The best thing to do is use Jeff plate and forget about a bell
houising.
Sooner or later you are going to need a motor mount. Our universal
motor mount is designed
to be used with Jeff's adapter plate. It is the lowest cost way to go.
Paul Lamar
Milo,
There appear to be 2 rx8 auto trans bell housings available on
car-part.com
<http://car-part.com>
Ed Carver
Ed,
Thanks a million, I will check it out
Milo
The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net. You Tube
http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.