Subject: Milo 's constant speed gear box
From: rotaryeng
Date: 7/27/2013, 8:55 AM
To: AAA-rotaryeng

I found myself in Milo's neck of the woods so I stopped in to take some pictures.

The whole Idea was to utilized re cycled Lyc crankshafts for the hard part which is the
prop shaft and prop flange. Lycoming constant speed prop shafts also have a gear
on them that drives the prop gov.

Lycoming crankshafts crack in the journal fillets so that leaves the front part OK.
According to Milo his suppliers has hundreds of them not usable for repair or over haul.

Milo took it one step further and sawed off the front of the crank case as well.
His supplier would rather sell old Lycoming cracked crank cases than weld them up
and use them in over hauls. Good idea. I would not like to buy an AC engine that had a
welded crankcase :)

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.