Subject: Milo 's constant speed gear box
From: rotaryeng
Date: 7/28/2013, 7:17 AM
To: AAA-rotaryeng



I found myself in Milo's neck of the woods so I stopped in to take
some pictures.

The whole Idea was to utilized re cycled Lyc crankshafts for the hard
part which is the prop shaft and prop flange. Lycoming constant speed
prop shafts also have a gear on them that drives the prop gov.

Lycoming crankshafts crack in the journal fillets so that leaves the
front part OK. According to Milo his suppliers has hundreds of them
not usable for repair or over haul.

Milo took it one step further and sawed off the front of the crank
case as well. His supplier would rather sell old Lycoming cracked
crank cases than weld them up and use them in over hauls. Good idea.
I would not like to buy an AC engine that had a welded crankcase :)

Paul Lamar


That is a DAMN GOOD idea!

Ben Lane

-- 

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.