Paul, I imagine you're familiar w/this build, probably some others on
this newsletter as well. Even so I had to share this epic build log from
rx7club.com <http://rx7club.com> :

http://www.rx7club.com/build-__threads-294/4-rotor-fc-build-__974831/
<http://www.rx7club.com/build-threads-294/4-rotor-fc-build-974831/>
Very
much worth the read, ENJOY!!

-Dan

Awsome.

Paul Lamar

On 08/13/2013 05:58 AM, BMB wrote: You can say that again Paul, and I
thought it was difficult drilling the Lycoming nose housing to fit the
bellhousing! milo

Robin sent him a message on Face Book. If he emails me I might
go over there in a few weeks. Robin is going to Germany and she
wants me to go with her. I would drive over from Frankfurt.
I could stop in at Wankel and AIXRO.

Paul Lamar
-- Copyright 1998-2013 All world wide rights reserved.

I wonder what steel alloy is best for the E-shafts?
Zoltan Szakaly