Subject: Low cost CD ignition and a1ternator Vespa.
From: rotaryeng
Date: 9/4/2013, 8:43 AM
To: AAA-rotaryeng





 Vespa Piaggio motor scooter stator and rotor has the potential for a
 low cost capacitor discharge ignition system.

 Milo has done some work on this already using much more expensive
 outboard motor parts. Vespa's are made in the millions and the cost of
 manufacture is much lower. The parts are pretty much the same as the
 outboard parts but smaller.

 The secret to this approach is the stator has a high voltage coil that
 charges the ignition capacitor. This is a much cheaper and more reliable
 way of providing 400 volts for the CD ignition.

 Here is a new one on ebay for $105 plus $24 for shipping. Made in Israel.
 Complete stator and rotating drum with magnets.

 The higher RPM rotary will generate higher capacitor charging current.

 This is a very low cost CD ignition system that will also provide a low
 current back up alternator in case the main electrical system fails.

 It is conceivable this will fit in my proposed new Ross copy gear box.

 Paul Lamar



 Paul,
 I could not find the $105 deal on Ebay. Do you have the contact number
 for the seller? Milo


 Here is a jpg of the ebay add

 Paul Lamar

 Paul,
 I can not get that page to come up! milo

 Try this


http://stores.ebay.com/Reut1209/_i.html?_nkw=Piaggio+stator&submit=Search&_sacat=Reut1209&_sid=833388452

 The store's name is Reut1209. Put that in google.

 They have 3277 parts.

 They sell the flywheel and stator separately.

 They may be sold out of the $105 combo because I cannot find it again.

 The Piaggio Typhoon Sfera and the Zip 50 cc air cooled 2 cycle engines
 are the
 same. 1991 to 2003


 You can also buy the High Tension coils separately. Two of those
 and a flywheel with magnets are all you need for an ignition system.
 One HT coil may not be enough. I have not tried it yet.

 Paul Lamar

Hi Paul,
On the 12a single rotor I used the Ford Edis4, with fixed advance. I would be interested in a parts set, that would proved an aircraft magnito function, installed on front of E-shaft Best Regards, Rolland




Rolland,
We considered the same option you have mentioned for the magneto to be mounted on the front of the e shaft, but at 9000 rpm for takeoff am not certain a small magnet rotor like found on the Piaggio would be strong enough to handle 9000 rpm. Milo

Force in G's = V squared divided by the radius.

V is the velocity of the magnet traveling around the circumference circle
in inches per second. The radius is the radius of the drum.
Weigh the magnet. Bolt one side of the drum to a solid place (mill table) and apply a tensile force with a hyd jack to the other side.


If that permanently distorts the drum wrap the outside with uni carbon and epoxy.

When I get a drum in a month of so I will have the dimension and magnet
weight to do that test.


Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.