Subject: Stud spacing on renesis exhaust
From: rotaryeng
Date: 9/10/2013, 2:19 PM
To: AAA-rotaryeng


Paul,
         Does anyone have a drawing of the exact stud spacing versus the exhaust openings in the engine.  problem is that the studs are not evenly spaced and offset to the openings, so need the drawing to manufacture the exhaust manifold for my renesis.

Neil.

I don't have an accurate dwg. The best way to handle this is obtain a piece of clear Lexan
plastic and place it over the side of the engine so you can lightly punch the center of the
holes and draw the ports.

Plexiglas will work but you have to be real careful not to crack it.

Another ancient way is pull the studs, tape on paper and  go lightly over with a lead pencil.


Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.