Paul, Does anyone have a drawing of the exact stud spacing versus the
exhaust openings in the engine. problem is that the studs are not
evenly spaced and offset to the openings, so need the drawing to
manufacture the exhaust manifold for my renesis.
Neil.
I don't have an accurate dwg. The best way to handle this is obtain a
piece of clear Lexan plastic and place it over the side of the
engine so you can lightly punch the center of the holes and draw the
ports.
Plexiglas will work but you have to be real careful not to crack it.
Another ancient way is pull the studs, tape on paper and go lightly
over with a lead pencil.
Paul Lamar
or buy a exhaust gaskedt and use it for a pattern.
chris smale