Subject: Plugs$$$$$$
From: rotaryeng
Date: 9/16/2013, 3:41 PM
To: AAA-rotaryeng

   HI Paul & Group,

   I'm finally ready to launch my bird after nine years of building.  I
   took the RX8 rotary powered beast out yesterday and fired it up,
   however I managed to foul the spark plugs after starting it a few
   times.  Went to order new spark plugs this morning and was knocked
   for a loop when I was told that the cost would be $20.00 each. No
   auto parts store stocks them, so I had them ordered.  I tried to
   clean them the way I always have with other conventional plugs but
   the attempt failed when I tried to re-start my rotary.  Do you have
   any method to clean them or then wire brush, compressed air & propane
   torch? Thanks.

Try Autolite AR2592. Used by racers. Ice cold. 1/2 Exposed center electrode. Next day service through any Autozone store. About $8.00 a box of 4.

   To clear a flooded Renisis remove the plugs. All of them. Disable the ignition (or it can be ruined). Disable the injection system so that the injectors cannot fire. With the prop off. The aircraft outside the hanger and the pin removed from a 50 pound CO-2 fire bottle manned by a WWII veteran who has used such a bottle. A second WWII vet will hold a big handful of fluffy cotton rags over the plug holes in order to catch the excess fuel as it sprays out of the plug holes, if any.

The throttle must be kept in the full open position during this operation. As always, chocks in place, tail wheel tied to the Buda or other fixed object. Owner at the controls with the brakes on hard.
Once the engine is clear. Spray in a few squirts of crank case oil into each housing. Again spin the engine to oil up the side seals.
Then replace the new clean dry plugs. And start the engine as normal.

Each time you start the engine let it get to operating temp. The hot plugs will keep themselves clean and dry right through the cooldown. Warm plugs will not.

The rotary is cold blooded. It needs some heat of compression to vaporize some fuel. Low compression, low heat of compression and you get no start. You can actually get liquid fuel burning and dripping out of the tail pipe, and still have no start. Don't go all limp now, you can do it on a Lycoming as well. So a sparkling fully charged battery. Short runs of copper wire the starter. Good compression readings (for heat of compression) ignition at about the right time, fuel in nearly any amount, and it will start. If you know for a fact that the idle screw is set
correctly, fine. If not screw it all the way down to zero. Change it only after the engine is warm. A rotary with no prop can reach its red line before a single thought can race across your mind. Revs first, then oil pressure. Have a good time.

Lynn E. Hanover

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.