Subject: WOW $$$ Spark Plugs
From: rotaryeng
Date: 9/16/2013, 10:14 AM
To: AAA-rotaryeng


HI Paul & Group,

I'm finally ready to launch my bird after nine years of building.  I
took the RX8 rotary powered beast out yesterday and fired it up,
however I managed to foul the spark plugs after starting it a few
times.  Went to order new spark plugs this morning and was knocked
for a loop when I was told that the cost would be $20.00 each. No
auto parts store stocks them, so I had them ordered.  I tried to
clean them the way I always have with other conventional plugs but
the attempt failed when I tried to re-start my rotary.  Do you have
any method to clean them or then wire brush, compressed air & propane
torch? Thanks.


Also, I'm having problems getting the six port RX8 to let me advance
to retard the throttle without it quitting.  I'm using Tracy's EC3
engine controller which I find very complicated to program, however
the engine does respond to any input or change I make to the EC3, so
I'm quit sure I have it wired correctly.  I'm not sure if I using the
right injector locations on the RX8 six port.  I'm using the four
yellow injectors that are located in a row.  I blocked off the two
red ports that are located behind to yellow ones.  When I removed the
original intake parts I did remove all the inner parts to it. Anyone
know if I'm using the right injectors ports, or have any suggestions.


Many Thanks, Bob Forbes N164WF


The problem is probably not the iridium plugs. The RX8 is notorious for storing raw fuel
in the rotor housing.

It won't start unless you get that out of the engine. Take the exhaust manifold
off and insert a small hose connected to a vacuum source to suck the raw fuel
out of the bottom of the rotor housing. A plastic squeeze bottle will work.
You can also go through the lower spark plug hole. The idea is the get
the small hose to the bottom of the rotor housings.

I would keep the high pressure fuel pumps off for a few rotations of the engine
when starting from cold. Tracy has never shared the source code on his EFI so
I have no idea what he is doing about the RX8 starting. Have you contacted Tracy
and asked him about the stumbling problem when changing the throttle position.

I am taking his EFI off my 13B powered RV4 and replacing it with a 2 barrel Holley carb.

If you want to keep EFI I recommend changing to Motec or Holley

http://www.motec.com/

http://www.holley.com/Index.asp?division=Holleyefi


Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.