HI Paul & Group,
I'm finally ready to launch my bird after nine years of building. I
took the RX8 rotary powered beast out yesterday and fired it up,
however I managed to foul the spark plugs after starting it a few
times. Went to order new spark plugs this morning and was knocked
for a loop when I was told that the cost would be $20.00 each. No
auto parts store stocks them, so I had them ordered. I tried to
clean them the way I always have with other conventional plugs but
the attempt failed when I tried to re-start my rotary. Do you have
any method to clean them or then wire brush, compressed air & propane
torch? Thanks.
Try Autolite AR2592. Used by racers. Ice cold. 1/2 Exposed center
electrode. Next day service through any Autozone store. About $8.00 a
box of 4.
To clear a flooded Renisis remove the plugs. All of them. Disable
the ignition (or it can be ruined). Disable the injection system so that
the injectors cannot fire. With the prop off. The aircraft outside the
hanger and the pin removed from a 50 pound CO-2 fire bottle manned by a
WWII veteran who has used such a bottle. A second WWII vet will hold a
big handful of fluffy cotton rags over the plug holes in order to catch
the excess fuel as it sprays out of the plug holes, if any.
The throttle must be kept in the full open position during this
operation. As always, chocks in place, tail wheel tied to the Buda or
other fixed object. Owner at the controls with the brakes on hard.
Once the engine is clear. Spray in a few squirts of crank case oil into
each housing. Again spin the engine to oil up the side seals.
Then replace the new clean dry plugs. And start the engine as normal.
Each time you start the engine let it get to operating temp. The hot
plugs will keep themselves clean and dry right through the cooldown.
Warm plugs will not.
The rotary is cold blooded. It needs some heat of compression to
vaporize some fuel. Low compression, low heat of compression and you get
no start. You can actually get liquid fuel burning and dripping out of
the tail pipe, and still have no start. Don't go all limp now, you can
do it on a Lycoming as well. So a sparkling fully charged battery. Short
runs of copper wire the starter. Good compression readings (for heat of
compression) ignition at about the right time, fuel in nearly any
amount, and it will start. If you know for a fact that the idle screw is
set correctly, fine. If not screw it all the way down to zero. Change it
only after the engine is warm. A rotary with no prop can reach its red
line before a single thought can race across your mind. Revs first, then
oil pressure. Have a good time.
Lynn E. Hanover
Try squirting a little either in the intake.
milo
Lest everybody gets the wrong idea this is not a serious problem.
It happened once when I first got the RX8 and not again in 9 years.
Just don't turn it off when it is still cold. Let it warm up every time
you start it up.
Paul Lamar