Subject: Follow up propeller and pictures
From: rotaryeng
Date: 9/18/2013, 8:45 PM
To: AAA-rotaryeng




Hi Paul,

I started to fly my RV-7A, even with the help you provided, It took 9 years
and 4 months and I still have finish work to do, Probably a year worth of
work.

I have one major issue with the propeller: Wood prop D = 76 in, Pitch = 88
in, Static RPM = 5700

No increase in RPM with speed increase, Take off takes over 1500 feet Top
speed 105 mph

I tried a Wood prop D = 69, P = 56, Static RPM over 7300 Could not fly it
because of vibration.

What would you suggest?

Thanks,

JP


Assuming you have a 2.85:1 gear box cut 4 inches off the first wood prop
diameter and rebalanced it.

Balance the second wood prop and try it again.

Pass a round bar through the hub and use horizontal and parallel steel bars
to static balance it.

Take some pictures of the intake manifold and email them to me.

Put the word "PRIVATE" in the email subject box if you don't want me to
publish them.

Paul Lamar


paul, curious: what's the interest in the intake? novice here, excuse me if
is stupid question........
jess


The key to tuning a rotary engine is the design and construction of the
intake manifold.

18 inch 2" OD  runners and a p-port is optimum.
Anything less that this is less power.

Paul Lamar



Good night Paul,

As promised, see pictures attached.
By the way, I cut my prop 1.5 inches today,
Ground test looked good, will fly it tomorrow if weather is fine.
Will cut another half inch if needed, will see!!!


PS, I am sending one picture, otherwise, may not go thru.


Thanks a lot

JP

What is inside the large box bolted to the side of the block?

P-port or side port?

If  each port does not have an individual long runner or tube there will be
very modest amount of  HP generated.

With no tubes or runners one would be lucky to see 100 HP.
The optimum length for the tubes or runners is around 18" with side ports
or P-ports.

If a side port engine is 200 HP a  p-port version
will be 250 HP.


Shorter runners than 18" indicates the max power will occur higher
than 7500 RPM which is not good for a 2.85:1 gear box.



Paul Lamar

 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.