This was quite a challenge getting it to fit under the existing cowl.
The solution was the S turns at the end of the 1.75" diameter runners.
Paul Lamar
That is some beautiful engineering and fabrication. I haven't seen a
purple engine since
Allis Chalmers introduced their "Road King" over the road truck engine
back in the late
sixties.
roger paxton
Mike Wills built it. He did a great job. I bought it from his widow.
Paul Lamar
Progress on the Holley installation. I had this 4 port manifold lying
around from the old
days when we were casting them and selling them. This was prior to the
P-port craze.
I lucked out in that Mike choose a 4 port 13B rather than a six port
13B. It really is a Turbo II engine with out the turbo.
Mike had kluged up a stock manifold so this one is far better looking
and looks more professional.
This is the rough position of the Holley. I may need a small bump in the
cowl but it could do double duty as a cold air intake. Lots of stuff is
coming off
the top of the engine as four injectors and all the plumbing and wiring
is no longer
needed.
Paul Lamar
Today was my lucky day. I was looking through my collection of old parts
and I came across these injector-holder/bell-mouths. Perfect for the Holley!
We used to cast these and sell them too...... way back.
Perfect for the Holley too. I will plug the injector holes.
You need to cut a lot of stuff off the top of the engine to have the
manifold
lie right down. Only takes a few minutes with hand held cut off friction
saw.
Finish with a die grinder. Ware a respirator and face shield. You want
to auger
in to at the end of life and not die of lung cancer :)
Manifold pictures courtesy of Bill Scherts. Ironically Bill did not use
it as it was still
too high. I have more room under the RV4 cowl than Bill had with the KIS
C cruiser. If he still has it maybe he will sell it.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net.
You Tube
http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.