Subject: Holley 2 barrel on my RV4
From: rotaryeng
Date: 9/18/2013, 5:11 PM
To: AAA-rotaryeng



  This was quite a challenge getting it to fit under the existing cowl.
  The solution was the S turns at the end of the 1.75" diameter runners.

  Paul Lamar


That is some beautiful engineering and fabrication.  I haven't seen a purple engine since Allis Chalmers introduced their "Road King" over the road truck engine back in the late sixties.

roger paxton

Mike Wills built it. He did a great job. I bought it from his widow.

Paul Lamar

Progress on the Holley installation. I had this 4 port manifold lying around from the old days when we were casting them and selling them. This was prior to the P-port craze.
I lucked out in that Mike choose a 4 port 13B rather than a six port 13B. It  really is a Turbo II engine with out the turbo.

Mike had kluged up a stock manifold so this one is far better looking and looks more professional.

This is the rough position of the Holley. I may need a small bump in the cowl but it could do double duty as a cold air intake. Lots of stuff is coming off the top of the engine as four injectors and all the plumbing and wiring is no longer needed.

Paul Lamar

Today was my lucky day. I was looking through my collection of old parts and I came across these injector-holder/bell-mouths. Perfect for the Holley!
We used to cast these and sell them too...... way back.

Perfect for the Holley too. I will plug the injector holes.

You need to cut a lot of stuff off the top of the engine to have the manifold lie right down. Only takes a few minutes with hand held cut off friction saw.
Finish with a die grinder. Ware a respirator and face shield. You want to auger in to at the end of life  and not die of lung cancer :)

Manifold pictures courtesy of Bill Scherts. Ironically Bill did not use it as it was still too high. I have more room under the RV4 cowl than Bill had with the KIS C cruiser. If he still has it maybe he will sell it.

Paul Lamar


Hi Paul,
   I see that the oil filler/breather hole has been blanked off, what is used instead ?
       Chris in NZ

Mike modified a 10 mm 1.25 pitch bolt to work as a hose barb.
Then he ran a 1.4 " ID rubber hose over board. The carb manifold interferes with
that so I have to work something else out. Actually the original
steel tube and oil  filler neck would still work because when we designed
that intake system way back I took that into consideration.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.












-- 

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.