Subject: Low cost CD ignition and a1ternator Vespa.
From: rotaryeng
Date: 9/18/2013, 10:17 AM
To: AAA-rotaryeng


Vespa Piaggio motor scooter stator and rotor has the potential for a
low cost capacitor discharge ignition system.

Milo has done some work on this already using much more expensive
outboard motor parts. Vespa's are made in the millions and the cost
of manufacture is much lower. The parts are pretty much the same as
the outboard parts but smaller.

The secret to this approach is the stator has a high voltage coil
that charges the ignition capacitor. This is a much cheaper and more
reliable way of providing 400 volts for the CD ignition.

Here is a new one on ebay for $105 plus $24 for shipping. Made in
Israel. Complete stator and rotating drum with magnets.

The higher RPM rotary will generate higher capacitor charging
current.

This is a very low cost CD ignition system that will also provide a
low current back up alternator in case the main electrical system
fails.

It is conceivable this will fit in my proposed new Ross copy gear
box.

Paul Lamar



Paul, I could not find the $105 deal on Ebay. Do you have the contact
number for the seller? Milo


Here is a jpg of the ebay add

Paul Lamar

Paul, I can not get that page to come up! milo

Try this


http://stores.ebay.com/Reut1209/_i.html?_nkw=Piaggio+stator&submit=Search&_sacat=Reut1209&_sid=833388452
<http://stores.ebay.com/Reut1209/_i.html?_nkw=Piaggio+stator&submit=Search&_sacat=Reut1209&_sid=833388452



The store's name is Reut1209. Put that in google.

They have 3277 parts.

They sell the flywheel and stator separately.

They may be sold out of the $105 combo because I cannot find it
again.

The Piaggio Typhoon Sfera and the Zip 50 cc air cooled 2 cycle
engines are the same. 1991 to 2003


You can also buy the High Tension coils separately. Two of those and
a flywheel with magnets are all you need for an ignition system. One
HT coil may not be enough. I have not tried it yet.

Paul Lamar

Hi Paul, On the 12a single rotor I used the Ford Edis4, with fixed
advance.  I would be interested in a parts set, that would proved an
aircraft magnito function, installed on front of E-shaft Best
Regards, Rolland


Hi Paul,

Shipping is too expensive and takes too long. I will try to bring the
rotors with me. Worst case is airport security says no and I lost
US$20

I put one upside down and op top of the other rotor. The magnetic
flux is now condensed mostly inside the rotor. I cannot feel any pull
to a screw driver stick to it so I assume it is OK to bring with me
on the plane. Anyway, I will test it again with a paper clip before I
go to the airport. I found that it is not illegal to ship magnets, it
just have to have really small amount of measurable flux so it will
not interfere with earth's magnetic field from 15 feet. (I think the
rule is half or less of earth's average magnetic field)

Henry

I'll pay the shipping. Got to be less than $100.
I really want those things. I am going to modify Tracy's
gear box and install it on the RV4 and flight test that ignition.

The carb is almost ready to go.

Can we order them and have the seller ship to the US?

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.