The problem is the ports are not round if you combine the outer ports to
one 2 inch OD tube. The same problem applies to the two center ports.
When I built the 4 port manifold back about 5 or ten years ago I used
the local college's 3D printing machine to make the core box's and patterns.
That machine is no longer available to me so an NC mill is now called
for to make
the transitions. Without an NC mill this is a daunting problem.
This is a major reason we went with p-ports. A simple round hole in the
rotor housing
and a simple round 180 bend tube is all we needed. This cut the cost of
an intake manifold
enormously. The extra 50 HP was a bonus.
JP, you would be better off going with your kludged up old stock
manifold and cut
the dynamic chamber off (if there is one) and move the pressure taps to
the intake
plenum. If you don't have it any more I will sell the 4 port one I have.
I don't have
a six port version.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net.
You Tube
http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.