Subject: My gear box ignition came in from Israel
From: rotaryeng
Date: 9/22/2013, 11:26 AM
To: AAA-rotaryeng


   Via ebay. I was not too optimistic about this. It was not due till Oct.
   It ill fit in the gear box no problem.

   Henry is bringing a back up from China. It will be interesting to compare them.

   The rotor actually fits inside the ring gear. Of course it will not reside there. The rotor
   will be a part of the rubber coupling. I will cut a large hole in Jeff's plate and fab a new
   bulkhead to take helical gear thrust.

   Paul Lamar

   Paul,

   I arrived O.C. with the Chinese rotors. Two sets of Rotors with Two sets of Stators) I realized that I can flip one Rotor over and stack two of them together. The magnetic flux will then be confined to the side of the two steel casing and I was able to bring both sets back to the USA in my checked luggage. (Even paper clip won't stick to the Rotor after they were stacked together)

   405 is fairly congested because of UCLA. (Students are moving in this weekend so a lot more traffic on I-405. road work around I-605 didn't help much either.

   Anyway, are you in town? If so, I will try to bring them up to you this week.

   Henry Nee

Any time Henry. I am at the hangar every day up to about 5 PM.

Paul Lamar


   The Rotary Engine News Letter. Powered by Linux.
   ACRE NL web site. http://www.rotaryeng.net.
   You Tube http://tinyurl.com/beqqxas.
   Copyright 1998-2013 All world wide rights reserved.