Subject: My gear box ignition came in from Israel
From: rotaryeng
Date: 9/22/2013, 2:23 PM
To: AAA-rotaryeng



 Via ebay. I was not too optimistic about this. It was not due till Oct.
 It ill fit in the gear box no problem.

 Henry is bringing a back up from China. It will be interesting to
compare them.

 The rotor actually fits inside the ring gear. Of course it will not
reside there. The rotor
 will be a part of the rubber coupling. I will cut a large hole in
Jeff's plate and fab a new
 bulkhead to take helical gear thrust.

 Paul Lamar

 Paul,

 I arrived O.C. with the Chinese rotors. Two sets of Rotors with Two
sets of Stators) I realized that I can flip one Rotor over and stack two
of them together. The magnetic flux will then be confined to the side of
the two steel casing and I was able to bring both sets back to the USA
in my checked luggage. (Even paper clip won't stick to the Rotor after
they were stacked together)

 405 is fairly congested because of UCLA. (Students are moving in
this weekend so a lot more traffic on I-405. road work around I-605
didn't help much either.

 Anyway, are you in town? If so, I will try to bring them up to you
this week.

 Henry Nee

Any time Henry. I am at the hangar every day up to about 5 PM.

Paul Lamar


Here is the rotor with the centerpiece removed and machined to pilot on  the
spline plate. Adds less than an inch of length to the overall length of the coupling.

The stator has three different windings giving three independent power supplies.
I assume the lowest voltage is for lighting but there is a medium voltage as well
as several hundred volt winding to charge the ignition capacitors.

Paul Lamar

 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net.
 You Tube http://tinyurl.com/beqqxas.
 Copyright 1998-2013 All world wide rights reserved.