Subject: My gear box ignition came in from Israel
From: rotaryeng
Date: 9/24/2013, 2:20 PM
To: AAA-rotaryeng



Via ebay. I was not too optimistic about this. It was not due till Oct.
It ill fit in the gear box no problem.

Henry is bringing a back up from China. It will be interesting to
compare them.

The rotor actually fits inside the ring gear. Of course it will not
reside there. The rotor
will be a part of the rubber coupling. I will cut a large hole in
Jeff's plate and fab a new
bulkhead to take helical gear thrust.

Paul Lamar

Paul,

I arrived O.C. with the Chinese rotors. Two sets of Rotors with Two
sets of Stators) I realized that I can flip one Rotor over and stack two
of them together. The magnetic flux will then be confined to the side of
the two steel casing and I was able to bring both sets back to the USA
in my checked luggage. (Even paper clip won't stick to the Rotor after
they were stacked together)

405 is fairly congested because of UCLA. (Students are moving in
this weekend so a lot more traffic on I-405. road work around I-605
didn't help much either.

Anyway, are you in town? If so, I will try to bring them up to you
this week.

Henry Nee

Any time Henry. I am at the hangar every day up to about 5 PM.

Paul Lamar


Here is the rotor with the centerpiece removed and machined to pilot onthe
spline plate. Adds less than an inch of length to the overall length of
the coupling.

The stator has three different windings giving three independent power
supplies.
I assume the lowest voltage is for lighting but there is a medium
voltage as well
as several hundred volt winding to charge the ignition capacitors.

Paul Lamar

Henry brought over the motorcycle ignition he got in China.
Slightly smaller than the Vespa I got from Israel.

With my mill set on the slowest speed I got 27 volts AC on the high voltage coils.
The mill is essential because you need to make some fine instruments in the
table to get the stator concentric with the rotor. Several layers of masking
tape around the coils help getting the stator adjusted.

I suspect these systems are designed to work on only 100 Volts or so. I need to do some
more experimenting with them. We may need the motor cycle coils.

I'll set the mill to go faster.

Paul Lamar


Is that 27V an open ckt measurement? I saw on one of the schematics posted here that they use a diode across the coil and a diode to the capacitor. This would allow current to build in the coil as one magnet pole approached. As the opposite pole approaches the stored current would discharge into the cap aided by the other pole. This should produce a higher cap voltage. Try connecting the additional circuitry and measure the DC on the cap.

Robert


You read my mind Robert. I was just about to dig up a diode and a cap.

Better yet I hauled the scope down there and got 100 volts AC peek to peek at 60 ms.
1000 RPM if my arithmetic is right.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.