Subject: My gear box ignition came in from Israel
From: rotaryeng
Date: 9/24/2013, 2:33 PM
To: AAA-rotaryeng



Via ebay. I was not too optimistic about this. It was not due till Oct.
It ill fit in the gear box no problem.

Henry is bringing a back up from China. It will be interesting to
compare them.

The rotor actually fits inside the ring gear. Of course it will not
reside there. The rotor
will be a part of the rubber coupling. I will cut a large hole in
Jeff's plate and fab a new
bulkhead to take helical gear thrust.

Paul Lamar

Paul,

I arrived O.C. with the Chinese rotors. Two sets of Rotors with Two
sets of Stators) I realized that I can flip one Rotor over and stack two
of them together. The magnetic flux will then be confined to the side of
the two steel casing and I was able to bring both sets back to the USA
in my checked luggage. (Even paper clip won't stick to the Rotor after
they were stacked together)

405 is fairly congested because of UCLA. (Students are moving in
this weekend so a lot more traffic on I-405. road work around I-605
didn't help much either.

Anyway, are you in town? If so, I will try to bring them up to you
this week.

Henry Nee

Any time Henry. I am at the hangar every day up to about 5 PM.

Paul Lamar


Here is the rotor with the centerpiece removed and machined to pilot onthe
spline plate. Adds less than an inch of length to the overall length of
the coupling.

The stator has three different windings giving three independent power
supplies.
I assume the lowest voltage is for lighting but there is a medium
voltage as well
as several hundred volt winding to charge the ignition capacitors.

Paul Lamar

Henry brought over the motorcycle ignition he got in China.
Slightly smaller than the Vespa I got from Israel.

With my mill set on the slowest speed I got 27 volts AC on the high
voltage coils.
The mill is essential because you need to make some fine instruments in the
table to get the stator concentric with the rotor. Several layers of masking
tape around the coils help getting the stator adjusted.

I suspect these systems are designed to work on only 100 Volts or so. I
need to do some
more experimenting with them. We may need the motor cycle coils.

I'll set the mill to go faster.

Paul Lamar

A part coming from Israel is a part coming 'Out of the blue'?

An old joke about a political  teleconference, where the
attendants had to make a decission, but the subject
was so complex, that all decided finally to make a phone call to God,
for getting His advise.
After a time, all complained about the high cost of the
phone call, with the exception of the ones in Jerusalem; when asked for the reason
why their call was much cheaper, the response was: 'It was a call inside the same area code'

Salut †          Jose Gros-Aymerich
Madrid, Spain



The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.