What do all you guys think of converting my RV4 to tricycle gear?
I have been told to wheel land it at 80 MPH.
That is a field length penalty and a much worse crash if you screw up.
As I understand it they are dangerous in cross wind landings. I have a
friend with one that refuses to fly under sever cross wind conditions.
Paul Lamar
It's not the beginning of April already is it ?
John
No john I am serious. I have already spent $1000 with some jerk up in
Oregon trying to teach me to wheel land at 80 MPH.
Actually most of the time was spent doing 360's just under the overcast
and just above the trees like I needed to do that :)
When a tail wheel airplane first touches a paved runway with any cross wind
component at all the side force is ahead of the CG and by any definition
that is severe instability.
Tails wheels were designed back in the days when dirt air fields were 2
miles square and you could always land into the wind.
Also the coefficient of friction of rubber tires on dirt or grass is much
less than on pavement.
I don't want to be put in position of either running out of gas or landing
in a cross wind with a tail wheel.
Paul Lamar
I learned to fly on a C120 and loved it. That one you could wheel land or 3
point land. The 3 pointer landing actually happened in a fairly short
distance as we were taught to try and touch the tailwheel down 1 second
before the mains so you didn't touch mains first and set up a bounce. Worked
like a charm and its the same technique as landing the tricycle just that
you hold it off a bit higher and a bit longer.
Touchdown speed was lower than a wheeler landing due to the high angle of
attack at touchdown. Are you not supposed to 3 point land a RV4? All serious
short field planes with tail dragged config seem to be able to land in a
reasonably short distance so I guess they 3 point land it,
Alex
Touching down on a locked tail wheel should work great. Maybe I should focus
on finding or making a locking tail wheel.
Paul Lamar
Dear Mr. Lamar:
I would check with the Kit manufacturer and ask IF they have any information
regarding landing a Tricycle Gear RV4 in crosswinds. As they offer a
Tricycle Gear option, they should have a chart or information about how it
handles in crosswind landings, etc. that should be in the aircraft manual.
I would also ask the Kit manufacturer IF they could send you the name and
addresses of several of their customers that have and fly a Tri Gear RV-4s.
I would contact those individuals. I am sure Tri Gear RV-4 owners and
operators could give you a lot of information based on experience how the
Tri Gear RV-4 handles in cross winds.
I would also check on installing Vortrice Generators on your airplanes wings
and tail to improve handling of your ariplane at low speeds.
All My Best
Brannen Sanders
http://www.vansairforce.com/community/showthread.php?t=29562
"The 8 has a larger rudder and longer fuselage and stiffer gear, is heavier
with different crosswind manners. To answer your question, in my
RV4 I used 20 knots max direct cross using a wheels landing, wing low on
touchdown technique. Any more and it's gets squirrley when you lower the
tail as the fuselage blanks alot of the rudder.The Rocket with an RV4 rudder
is even more pronounced.
Most production taildraggers use 17 knots direct crosswind as a limit. I
asked a FSDO guy once about that and he said that years ago all of the
manufacturers got together and agreed on a number, the insurance companies
liked it and there it was, 17 knots. Your mileage may vary..."
"Rob Ray
1500 Hours RV4
HR2"
So apparently the rudder is blanked and that is why they insist on wheel
landings.
Back to nose gear :)
Paul Lamar
If I remember correctly wheel landings were done only a few MPH faster than
full stall landings. Used to get good control with rudder and aileron,
perhaps one brake in a cross wind. People that do it, do it all of the time.
Just to keep a keen edge on that tool. If you cannot stay on the centerline
during approach with bank and rudder, you need to use a different runway, or
airport.
You are not landing at 80 MPH. You are flying across an airport with the
wheels on the ground. That would be a low pass. Just get in some slow time
in a Champ or Cub and an old instructor. You just cannot beat conventional
gear for getting in and out of short fields.
I got stuck out in a cross wind and low on fuel over a paved airport that
had gas. I could not stay over the runway in my BC12D, so I landed on the
turn around circle at the end right into the stiff wind. A couple of boys
came out and clipped a rope into the tie down ring on the right wing and
walked me to the fuel pumps.
Lynn E. Hanover
The airplane is finished and flying.
Since the tail is blanked at 3 point landing angles of attack perhaps
vortex generators on the canopy and fuselage sides would help.
A larger rudder with more area at the bottom would also help. The rudder is
structurally weak anyway and prone to flutter at speeds over 200 MPH. We
considered making a new balanced one out of carbon fiber to stop that. The
stock RV4 rudder is not balanced. The balanced part at the top would help.
Van should be doing this.
A tall wheel faring that looks like a rudder would also help.
Paul Lamar
Hallo Paul
stay with taildragger, crosswind landings are no problem, we land with ours
(look at the pics on my FB) at 12 kts x-wind regularly without any
difficulty. Real pilots fly taildragger, tricycle is for farmers.
Dusan Mrna
Prague, Czech Rep.
Real men get drunk and pick fights in bars too :)
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.