Subject: slide throttle p-port car
From: rotaryeng
Date: 10/1/2013, 11:39 PM
To: AAA-rotaryeng <rotaryeng@earthlink.net>, Tom McNeilly <tomcn@earthlink.net>

This is made from a Holley float bowl and an off-shelf  McNeilly leaning
block. It is integrated into the 2 rotor existing slide throttle kit for p-ports
so it is real reasonable for a carb. Less than $400.

I came to the conclusion that the fuel orifices  don't have to be
in the metal carb body. As long as they are located near the float
level  and up stream from the throttle it will work.
In this case rubber hose is used to connect the fuel orifices with
the float bowl and mixture control. Very simple and very low cost.

Since it is a side draft it is lower profile than the Holley 2 barrel.
It is also more streamlined internally so it will generate more power.
Just a straight shot into the engine.

No choke necessary as you start it full rich.
No accelerator pump as you move the throttle slowly and at full
rich. The blue lever hanging down is the mixture control.

This is a low profile set up so it will fit in almost every side
by side airplane. We have some  new water pump modes to
give room for the laid back intake tubes.

It is conceivable and simple enough one  could make their  own.

Paul Lamar

-- 

 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.