This is made from a Holley float bowl and an off-shelf McNeilly leaning
block. It is integrated into the 2 rotor existing slide throttle kit for
p-ports
so it is real reasonable for a carb. Less than $400.
I came to the conclusion that the fuel orifices don't have to be
in the metal carb body. As long as they are located near the float
level and up stream from the throttle it will work.
In this case rubber hose is used to connect the fuel orifices with
the float bowl and mixture control. Very simple and very low cost.
Since it is a side draft it is lower profile than the Holley 2 barrel.
It is also more streamlined internally so it will generate more power.
Just a straight shot into the engine.
No choke necessary as you start it full rich.
No accelerator pump as you move the throttle slowly and at full
rich. The blue lever hanging down is the mixture control.
This is a low profile set up so it will fit in almost every side
by side airplane. We have some new water pump modes to
give room for the laid back intake tubes.
It is conceivable and simple enough one could make their own.
Paul Lamar
Paul,
Wondered if you are going to build one?
The tubes located on the runners and the float bowl level have to be in
alignment?
That would dictate where the bowl would have to be located?
Thanks for any input.
Joe Berki
Yes. Exactly and this is located properly.
I can make it in a day. I have all the parts.
I am looking for somebody that has a p-port engine ready to run
with gear box and prop to test it.
Anybody need a manifold and carb for a p-port engine?
I have a running RX8 P-port engine but I would need to build
a test stand and take the gear box and prop off the RV4.
I can use the wall outlet CDI for the ignition.
Paul Lamar