Subject: slide throttle p-port car
From: rotaryeng
Date: 10/2/2013, 8:10 AM
To: AAA-rotaryeng



 This is made from a Holley float bowl and an off-shelf  McNeilly leaning
 block. It is integrated into the 2 rotor existing slide throttle kit for
 p-ports
 so it is real reasonable for a carb. Less than $400.

 I came to the conclusion that the fuel orifices  don't have to be
 in the metal carb body. As long as they are located near the float
 level  and up stream from the throttle it will work.
 In this case rubber hose is used to connect the fuel orifices with
 the float bowl and mixture control. Very simple and very low cost.

 Since it is a side draft it is lower profile than the Holley 2 barrel.
 It is also more streamlined internally so it will generate more power.
 Just a straight shot into the engine.

 No choke necessary as you start it full rich.
 No accelerator pump as you move the throttle slowly and at full
 rich. The blue lever hanging down is the mixture control.

 This is a low profile set up so it will fit in almost every side
 by side airplane. We have some  new water pump modes to
 give room for the laid back intake tubes.

 It is conceivable and simple enough one  could make their  own.

 Paul Lamar



Paul,

Wondered if you are going to build one?
The tubes located on the runners and the float bowl level have to be in
alignment?
That would dictate where the bowl would have to be located?
Thanks for any input.

Joe Berki

Yes. Exactly and this is located properly.

I can make it in a day. I have all the parts.

I am looking for somebody that has a p-port engine ready to run
with gear box and prop to test it.


Anybody need a manifold and carb for a p-port engine?


I have a running RX8 P-port engine but I would need to build
a test stand and take the gear box and prop off the RV4.

I can use the wall outlet CDI for the ignition.

Paul Lamar




a word of caution from experience past... be VERY mindful of 1) the rubber
hoses sitting on top of the exhaust manifold, and 2) a float bowl boiling on
the manifold as well.   A shield would be the very least of my separation
methods.

Gary Buster
East Texas

Yep. Will do Gary.


Paul Lamar
-- 

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.