Subject: My RV4 Holley 2 Bar carb installation
From: rotaryeng
Date: 10/9/2013, 7:18 AM
To: AAA-rotaryeng



    This is coming along well. I will need a bump on the cowl but it
can do
    double duty as a cold air scoop.

    I got rid of an amazing amount of stuff when I took out Tracy's EFI.
    It  is now almost as simple as an aircraft engine.

    Paul Lamar



Paul,

What does the Holley and leaning block weigh? Simple is good in the air.

Regards,

Matt

About 5 pounds but that is off set by the weight of a throttle body,
four injectors and computer. Not far from a wash.

Here is  how much sticks out of the cowl roughly.

Paul Lamar


Paul, you can mill the choke tower off for better airflow with a low
profile carb hat; its standard practice on blow through turbo setups
with Holleys.

   Everett Rankin


   I was wondering about that. Thanks for the tip. Will do.

   What does that .25 inch dia. steel tube do that comes straight out of
   the top ?
   Can I cut that off too?

Paul Lamar

Those are the bowl vents. The taller the better. Top ends in still air to the extent possible. Can be within two diameters of the air filter top.
Notice the cut angles face outboard into the air flow into the carb.
So air pressure in the bowl goes up a micro amount with higher air flow into the carb. Just a bit of self correcting mixture. Not a factor if you change jets or you have leaning control. Note that if you hit a bump in the car fuel may slop out of the tube but is sucked back into the throat.
So no negative "G" with auto carbs. In IMSA RS series we ran the bowl vents up to the top of the air filter housing and tied them (3) together so they all saw the same pressure. We had to use the stock (sort of) Niki 4 barrel carbs. Under hard braking one bowel vent would dump fuel into the throats and flood the engine. Same thing in right hand turns.
Rick Engman took the time to show is newbies how to mod the carb for high "G: operation.

Lynn E. Hanover

Thanks Lynn. So if one is into negative G aerobatics one might want to stick with Motec EFI.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.