This is coming along well. I will need a bump on the cowl but it
can do
double duty as a cold air scoop.
I got rid of an amazing amount of stuff when I took out Tracy's EFI.
It is now almost as simple as an aircraft engine.
Paul Lamar
Paul,
What does the Holley and leaning block weigh? Simple is good in the air.
Regards,
Matt
About 5 pounds but that is off set by the weight of a throttle body,
four injectors
and computer. Not far from a wash.
Here is how much sticks out of the cowl roughly.
Paul Lamar
Paul, you can mill the choke tower off for better airflow with a low
profile carb hat; its standard practice on blow through turbo setups
with Holleys.
Everett Rankin
I was wondering about that. Thanks for the tip. Will do.
What does that .25 inch dia. steel tube do that comes straight out of
the top ?
Can I cut that off too?
Paul Lamar
That is your vent for the float bowl. If it is too low you take the
chance of fuel spilling out. But there are modifications that can be
done there to accomplish your needs.
Bob Mears
As Lyn mentioned.
I'll connect a small hose to it. If I point it into the direction of the
air flow into the carb
I will get this much increase in total pressure above the fuel.
That will richen the mixture above and beyond what the venturi can suck out
of the float bowl.
MPH PSI
50 0.0
60 0.1
70 0.1
80 0.1
90 0.1
100 0.2
110 0.2
120 0.3
130 0.3
140 0.4
150 0.4
160 0.5
170 0.5
180 0.6
190 0.7
200 0.7
210 0.8
220 0.9
230 1.0
240 1.0
250 1.1
260 1.2
270 1.3
280 1.4
290 1.5
300 1.6
310 1.7
320 1.8
330 2.0
340 2.1
350 2.2
360 2.3
370 2.5
380 2.6
390 2.7
400 2.9
Programed in QB64.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.