Subject: oil pressure direct out of the pump.
From: rotaryeng
Date: 10/14/2013, 2:30 AM
To: AAA-rotaryeng

    I'll bet you never saw this before :)

    Pull the plug on the cast in oil gallery and tap to 3/8-18.
    Don't over do it as you could crack the cast iron front end housing.
    People claim taking the oil out of here (rather than the front cover)
    going to the oil cooler reduces the oil temp 10 F.
    Several sharp 90 degree turns eliminated.

    Fast moving fluid does not like 90 degree turns.

    Unsubstantiated.

    Paul Lamar

    Paul,
       I used my CCM (Cheap chinese Mill) to make an aluminum block with
    an "O" ring recess (to seal to the end hsg) and a pipe thread port (for the
    hose fitting) to bolt to the hsg useing existing studs (like "Mistral" did)..

      I also drilled the oil gallery slightly larger as I felt that a 3/8-18 fitting
    was too restrictive but is about all could be done without the danger of
    cracking the hsg and making expensive junk out of it..

      I have seen the suggestion somewhere of threading this area for a
    pipe thread but if the tapered pipe tap does not crack the hsg then the
    fitting itself probably will if tightened enough to prevent leaking..

     Kelly Troyer
    Dyke Delta_"Eventually"
    13B_RD1C_EC2_EM2

Use an aluminum pipe thread and use Teflon tape.
The aluminum is soft enough not to crack the cast iron.

Some housing are already taped and have a steel pipe thread
plug in them. Both Mike's turbo engine and the 3 rotor I have
both are taped.

Here is the Mistral system pictures.

Paul Lamar



-- 

 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.