Subject: oil pressure direct out of the pump.
From: rotaryeng
Date: 10/14/2013, 8:08 AM
To: AAA-rotaryeng



Pull the plug on the cast in oil gallery and tap to 3/8-18. Don't
over do it as you could crack the cast iron front end housing. People
claim taking the oil out of here (rather than the front cover) going
to the oil cooler reduces the oil temp 10 F. Several sharp 90 degree
turns eliminated.

Fast moving fluid does not like 90 degree turns.

Unsubstantiated.

Paul Lamar

Paul, I used my CCM (Cheap chinese Mill) to make an aluminum block
with an "O" ring recess (to seal to the end hsg) and a pipe thread
port (for the hose fitting) to bolt to the hsg useing existing studs
(like "Mistral" did)..

I also drilled the oil gallery slightly larger as I felt that a
3/8-18 fitting was too restrictive but is about all could be done
without the danger of cracking the hsg and making expensive junk out
of it..

I have seen the suggestion somewhere of threading this area for a
pipe thread but if the tapered pipe tap does not crack the hsg then
the fitting itself probably will if tightened enough to prevent
leaking..

Kelly Troyer Dyke Delta_"Eventually" 13B_RD1C_EC2_EM2

Use an aluminum pipe thread and use Teflon tape. The aluminum is soft
enough not to crack the cast iron.

Some housing are already taped and have a steel pipe thread plug in
them. Both Mike's turbo engine and the 3 rotor I have both are
taped.

Here is the Mistral system pictures.

Paul Lamar


I used the base of a spark plug with straight threads and  integral
seal washer. Brazed the plug base to an AN -10 male fitting.

Robert

--
Good idea.

BTW Robert have you been for a ride in Dave Leonard's turbo RV6?

He is in your neck of the woods.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
http://www.rotaryeng.net <http://www.rotaryeng.net/ You Tube
http://tinyurl.com/beqqxas Copyright 1998-2013 All world wide rights
reserved.