Subject: oil pressure direct out of the pump.
From: rotaryeng
Date: 10/14/2013, 10:49 AM
To: AAA-rotaryeng


   Pull the plug on the cast in oil gallery and tap to 3/8-18. Don't
   over do it as you could crack the cast iron front end housing. People
   claim taking the oil out of here (rather than the front cover) going
   to the oil cooler reduces the oil temp 10 F. Several sharp 90 degree
   turns eliminated.

   Fast moving fluid does not like 90 degree turns.

   Unsubstantiated.

   Paul Lamar

   Paul, I used my CCM (Cheap chinese Mill) to make an aluminum block
   with an "O" ring recess (to seal to the end hsg) and a pipe thread
   port (for the hose fitting) to bolt to the hsg useing existing studs
   (like "Mistral" did)..

   I also drilled the oil gallery slightly larger as I felt that a
   3/8-18 fitting was too restrictive but is about all could be done
   without the danger of cracking the hsg and making expensive junk out
   of it..

   I have seen the suggestion somewhere of threading this area for a
   pipe thread but if the tapered pipe tap does not crack the hsg then
   the fitting itself probably will if tightened enough to prevent
   leaking..

   Kelly Troyer Dyke Delta_"Eventually" 13B_RD1C_EC2_EM2

   Use an aluminum pipe thread and use Teflon tape. The aluminum is soft
   enough not to crack the cast iron.

   Some housing are already taped and have a steel pipe thread plug in
   them. Both Mike's turbo engine and the 3 rotor I have both are
   taped.

   Here is the Mistral system pictures.

   Paul Lamar


   I used the base of a spark plug with straight threads and integral
   seal washer. Brazed the plug base to an AN -10 male fitting.

   Robert

   --
   Good idea.

   BTW Robert have you been for a ride in Dave Leonard's turbo RV6?

   He is in your neck of the woods.

   Paul Lamar

You face off the end of the "As cast" feature and prepare the hole for a straight thread "Tube to Boss" fitting. An "O" ring seals the fitting not the wedge effect of a tapered pipe fitting. The spark plug idea is about the same thing. This eliminates the "O" ring junction between the iron and the front cover that fails so often in cold starts. Replace that "O" ring with a thick aluminum disc. About .050" to .060" to seal the junction.

While you have the iron clamped in the mill, do that same thing to the gallery above, and run an oil line direct to the front stationary gear and bearing. Leave the dowel gallery open and have two oil lines feeding the front stationary gear. The front bearing fails first when oil pressure is very low or lost. Feed this oil line from the aluminum block on the oil filter stand.

Because we use an external pump, we do not do the first mod. The front aluminum housing has a plug at the oil out hole. But all Daryl Drummond (and many other builders) engines use the second mod.
Lynn E. Hanover


Don't get the idea this is essential for an aircraft engines. The racers, like Lynn, are turning 11,000 RPM
and spending most of the time 8500 to 11,000 RPM.

We see up to 7500 RPM for take off and cruise at 4500 to 6000.

Paul Lamar

   The Rotary Engine News Letter. Powered by Linux. ACRE NL web site.
   http://www.rotaryeng.net <http://www.rotaryeng.net/ You Tube
   http://tinyurl.com/beqqxas Copyright 1998-2013 All world wide rights
   reserved.