Subject: New RX8 side port manifold.
From: rotaryeng
Date: 10/17/2013, 9:23 PM
To: AAA-rotaryeng



   This is a very flexible design that can be used with a variety of tube bends to put the throttle
   body or carb just about anywhere you want it. Carb or EFI. Can also be tuned by changing the length
   of the runners to move the torque peak up and down the RPM range. As a rule of
   thumb the HP peak is about 1500 to 2000 RPM above the torque peak. 18 to 20 inches long puts the
   torque peak about 6000 RPM and the HP peak at about 7500.

   The two outer ports on each side are combined into one for less skin friction drag inside
   the runners.

   We can also tig one up to your specs.

   Paul Lamar

Paul, roughly how much less power would one get in this RX8 side port config instead of the 250hp on a PPort,

would it still be around 200, or a bit more?

Alex

Given a 2.85 to 1 gear box 200 HP is achievable but it probably requires a bit of porting
with a die grinder inside the engine. If one takes it apart to "port" it one  might as well go
with a p-port. My guess is 180 to 190 HP at 7500 RPM if everything is done right including the prop.
I highly recommend a ground adjustable prop like the Sensenich. You might need three blades
but the hub is easy to make. Warp Drive pioneered the ground adjustable hub that just
about everybody is  using it now. It has become an industry standard and adopted by Sensenich.


Paul Lamar


   The Rotary Engine News Letter. Powered by Linux.
   ACRE NL web site. http://www.rotaryeng.net.
   You Tube http://tinyurl.com/beqqxas.
   Copyright 1998-2013 All world wide rights reserved.