Hi Paul, here are pics of the finished tango nosegear mount for
   the welded portion of it. The welder did a great job on it,

        Alex



        Hey Alex, I really like that nosegear mount you have. I have a
   Tango Foxtrot4 on order, would your nosegear mount work on that?

        Thanks,
        Zoltan

   The tango MM won't work on a foxtrot as your firewall is larger than
   the tango and the tubes need to be located close to the firewall
   edge for maximum strength but Kevin can easily use the standard
   foxtrot motor mount jig and make one up, the same way he's doing for
   Bruce Cosgrove's tango on the standard tango jig. I couldn't use the
   standard teamtango MM jigs because my firewall holes were predrilled
   when tjere was a subaru hanging off it and slightly off the standard
   amount locations by about 1/2" at each location. Mine cost $1126 in
   labour and i think Teamtango paid for the tubing,
   Alex

   Zoltan, we can make that part but you must pay cash :) Deposit
   required. Balance COD.
   You can come up to SZP and watch us weld it :)
   We will mock it up and build your entire universal motor mount as well.

   All I need is a hole pattern dimensions for the firewall, the
   position of the thrust line
   and the length of the cowl from prop flange to firewall. It is best
   the match drill the firewall
   after the motor mount is done.

   I suggest moving the upper right (pilot-view) hard point 2 inches
   inboard to facilitate
   a vertically mounted water cooling rad on the right side of the engine .
   Some additional reinforcement behind the firewall is called for.

   Paul Lamar

   -- The Rotary Engine News Letter. Powered by Linux. ACRE NL web
   site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2013 All world wide rights reserved.