Subject: New RX8 side port manifold.
From: rotaryeng
Date: 10/19/2013, 7:43 PM
To: AAA-rotaryeng





       This is a very flexible design that can be used with a variety
  of tube bends to put the throttle
       body or carb just about anywhere you want it. Carb or EFI. Can
  also be tuned by changing the length
       of the runners to move the torque peak up and down the RPM
  range. As a rule of
       thumb the HP peak is about 1500 to 2000 RPM above the torque
  peak. 18 to 20 inches long puts the
       torque peak about 6000 RPM and the HP peak at about 7500.

       The two outer ports on each side are combined into one for less
  skin friction drag inside
       the runners.

       We can also tig one up to your specs.

       Paul Lamar

  Paul, roughly how much less power would one get in this RX8 side
  port config instead of the 250hp on a PPort,

  would it still be around 200, or a bit more?

  Alex

  Given a 2.85 to 1 gear box 200 HP is achievable but it probably
  requires a bit of porting
  with a die grinder inside the engine. If one takes it apart to
  "port" it one  might as well go
  with a p-port. My guess is 180 to 190 HP at 7500 RPM if everything
  is done right including the prop.
  I highly recommend a ground adjustable prop like the Sensenich. You
  might need three blades
  but the hub is easy to make. Warp Drive pioneered the ground
  adjustable hub that just
  about everybody is  using it now. It has become an industry standard
  and adopted by Sensenich.


  Paul Lamar


  Ok noted. I think I will still p-port mine then, after I have it in
  the sky and flying. Ill probably buy another motor and p-port that
  one so I can keep flying until I'm ready to swap them out

  Alex


       The Rotary Engine News Letter. Powered by Linux.
       ACRE NL web site. http://www.rotaryeng.net.
       You Tube http://tinyurl.com/beqqxas.
       Copyright 1998-2013 All world wide rights reserved.