This is a very flexible design that can be used with a variety of
tube bends to put the throttle body or carb just about anywhere you
want it. Carb or EFI. Can also be tuned by changing the length of the
runners to move the torque peak up and down the RPM range. As a rule
of thumb the HP peak is about 1500 to 2000 RPM above the torque peak.
18 to 20 inches long puts the torque peak about 6000 RPM and the HP
peak at about 7500.
The two outer ports on each side are combined into one for less skin
friction drag inside the runners.
We can also tig one up to your specs.
Paul Lamar
Paul, roughly how much less power would one get in this RX8 side port
config instead of the 250hp on a PPort,
would it still be around 200, or a bit more?
Alex
Given a 2.85 to 1 gear box 200 HP is achievable but it probably
requires a bit of porting with a die grinder inside the engine. If
one takes it apart to "port" it one might as well go with a p-port.
My guess is 180 to 190 HP at 7500 RPM if everything is done right
including the prop. I highly recommend a ground adjustable prop like
the Sensenich. You might need three blades but the hub is easy to
make. Warp Drive pioneered the ground adjustable hub that just about
everybody is using it now. It has become an industry standard and
adopted by Sensenich.
Paul Lamar
Ok noted. I think I will still p-port mine then, after I have it in
the sky and flying. Ill probably buy another motor and p-port that
one so I can keep flying until I'm ready to swap them out
Alex
Another thing that must be done right, carb or EFI, is the fuel
supply. Rotaries and piston engines burn about .65 pounds of fuel per
HP at full power full rich 12.5:1 mixture ratio.
At 250 HP that is 162.5 pounds per hour or 26 gallons an hour at 6.25
pounds per gallon. That is marginal for some fuel pumps. Especially
if they have the wrong AN dash 6 fittings. I bought four 1/8th pipe
to AN6 male fittings and the hole in the fitting was way under size.
Buy steel fittings so you can drill them out to near AN6 hose ID
specifications. Steel being stronger than aluminum and they will
tolerate a thinner wall. The devil is in the details :)
Paul Lamar
Don't those pumps have 1/4 NPT ports and not 1/8 NPT? Going from a 1/8
NPT thread to a -6 AN on a fitting would make it difficult to get a
reasonable through bore.
Gary Knutson
That kind of surprised me too.
The Walbro pump shown in the first picture is a 3/8th 24 straight thread
adapted to AN6.
The hole is still marginal. I have a couple of low pressure pumps for
the carb version that are both 1/8th NPT.
I double checked. Here is a picture of a 1/8 pipe tap screwed into the
hole in a low
pressure pump. Of course 1/8th pipe is a lot larger than .125". It is
about 3/8th ID.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net.
You Tube
http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.