Subject: New RX8 side port manifold.
From: rotaryeng
Date: 10/21/2013, 9:36 AM
To: AAA-rotaryeng


This is a very flexible design that can be used with a variety
   of tube bends to put the throttle
body or carb just about anywhere you want it. Carb or EFI. Can
   also be tuned by changing the length
of the runners to move the torque peak up and down the RPM
   range. As a rule of
thumb the HP peak is about 1500 to 2000 RPM above the torque
   peak. 18 to 20 inches long puts the
torque peak about 6000 RPM and the HP peak at about 7500.

The two outer ports on each side are combined into one for less
   skin friction drag inside the runners.

We can also tig one up to your specs.

Paul Lamar

   Paul, roughly how much less power would one get in this RX8 side
   port config instead of the 250hp on a PPort,

   would it still be around 200, or a bit more?

   Alex

   Given a 2.85 to 1 gear box 200 HP is achievable but it probably
   requires a bit of porting
   with a die grinder inside the engine. If one takes it apart to
   "port" it one  might as well go
   with a p-port. My guess is 180 to 190 HP at 7500 RPM if everything
   is done right including the prop.
   I highly recommend a ground adjustable prop like the Sensenich. You
   might need three blades
   but the hub is easy to make. Warp Drive pioneered the ground
   adjustable hub that just
   about everybody is  using it now. It has become an industry standard
   and adopted by Sensenich.


   Paul Lamar


   Ok noted. I think I will still p-port mine then, after I have it in
   the sky and flying. Ill probably buy another motor and p-port that
   one so I can keep flying until I'm ready to swap them out

   Alex

Another thing that must be done right, carb or EFI, is the fuel supply.
Rotaries and piston engines burn about .65 pounds of fuel per HP at
full power full rich 12.5:1 mixture ratio.

At 250 HP that is 162.5 pounds per hour or 26 gallons an hour at 6.25 pounds per gallon.
That is marginal for some fuel pumps. Especially if they have the wrong AN dash 6 fittings.
I bought four 1/8th pipe to AN6 male fittings and the hole in the fitting was way under size.
Buy steel fittings so you can drill them out to near AN6 hose ID specifications. Steel being stronger
than aluminum and they will tolerate a thinner wall. The devil is in the details :)

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.