Subject: 12 Volt in High Voltage supply for CD.
From: rotaryeng
Date: 11/4/2013, 4:16 PM
To: AAA-rotaryeng

The Linear Technology LT3751 Capacitor Charger Controller  DEMO CIRCUIT 1322
did not work and there was no guarantee. $175 down the drain.

I am getting it rebuilt by a surface mount shop in Goleta CA but I am not
getting my hopes up that it will start working.

However I am using that transformer design and a 555 oscillator to build my own.
I don't need all those bells and whistles that LT3751 chip has. So far my
experience with these kinds of chips has been very negative. I have spent too many
hours fooling with them and they are very unreliable.

A simple old CMOS 555  $1 oscillator and a FET pulsing the primary of a 10:1 transformer is all
one should need for a HV supply for the cap discharge ignition modules that
are now working fine.  I will use the current IGBT as they are cheaper by the dozen. I'll let you
know how it all works of course.

I need this CD ignition for the RV4 as it has a carb.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.