I have not heard any bad things about RX8 tension bolts so far
but it might be a good idea if you have an RX8 engine to remove
the bolts one at a time and coat them with silicone rubber.
Then replace them after you accomplish that for each one.
Do this one at a time so you don't affect the stock sealing between
end housings and rotor housings.
13b engine tension bolts would vibrate and fatigue if you ran
the engine at high power at a fixed RPM.
One step up from this was to replace all the stock 10 mm (.394") bolts
with half inch bolts. It take a special drill jig to drill out the
end housings. Mazdatrix has such a drill jig.
The latest trick, with custom aluminum end housing, is use a long
steel rod threaded on both ends and use nuts on both ends.
This removes the bending loads due to vibration on the threaded portion
of the tension bolts screwed into the front end housing.
If you want your engine to last more than 15 years install Iannetti ceramic
apex seals. Projected life for the ceramic apex seals is then 20,000 hours.
Not 2,000 hours.....20,000 hours!
However I have no idea how long the side seals would last.
My suggestion is use Mobil 1 fully synthetic oil in the sump.
I have years of experience with this oil in my street cars and
the engines last over 300,000 miles while a lot of
the stuff on the engine failed and had to be replaced.
Of course mix 2 cycle oil with the fuel to lube the seals.
Paul Lamar
The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.