Subject: To P-Port or not to P-Port
From: rotaryeng
Date: 11/25/2013, 6:49 PM
To: AAA-rotaryeng



I'm looking for a strong 180-200 hp from a 13B, knowing that PP would
get well beyond that. Would the different street porting options give
me what I need?


Jeff Williams


You have to take it apart to street port it.
The side port intake manifold is then a problem.

It is easier and cheaper to P-port it.

The manifold then becomes two 2 " OD 180 degree bends.

I have a sale on slide throttle kits. $100.

I can also weld up a P-port Holley 2 barrel manifold for you.

Paul Lamar




Some of the online rebuilders suggest that a new housing be used for the PP mod, are you saying if the housing are in spec, I can pp without replacing them? The eng. that I"m considering is low mileage (heard that before) 83,000 ml the rotors do spin. What you are suggesting will save a lot of money.

Jeff Williams

83,000 for a rotary that has not been severely over heated or starved
for oil is nothing. A low mileage rotary. Rotaries typically go over 300,000
miles. I have owned sixstrating with a new RX2 in 1973 and several of them
have gone over 300K.

Sure. You can p-port any housings. Some housing I have seen are really
scratched badly. The engine will still run.  Usually a really scatched house won't
start. If you can get it started it will run fine at  high speed.
A rotary is a little like a jet engine. It is almost a continuous combustion
engine.


Paul Lamar


-- 

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.