Subject: Major break through in rotary ignition
From: rotaryeng
Date: 12/16/2013, 2:53 AM
To: AAA-rotaryeng


The spark was impressive! A bright blue high density. 50,000 sparks
per second

I could not comprehend what I was seeing.

That is 3 million RPM in a rotary. No wonder the 2nd gen RX7 coil
failed.

Yes ....3 million RPM sparking once per revolution.

10 sparks per revolution 300,000 RPM.

100 sparks per revolution 30,000  RPM.

I am building three new systems to do some more testing.

Now all we need to do is figure out how to get the coil to live.

We may have to back off on the battery voltage.

Better pictures shortly.

Paul Lamar



What did you use as a trigger for that frequency? Kevin Alderman

A pulse generator.

In actual operation it will be limited by the number of teeth on the
trigger wheel. A 6" dia. #35 chain sprocket (3/8 pitch) would be
limited to 30 pulses per revolution for a 2 rotor. About one pulse
every 6 degrees of e-shaft angle. Well under the maximum capability
of this ignition system.  One ignition system per rotor if you use a
waste spark coil. You could also use 4 ignition systems and 4 coils.
One  per plug. Highly redundant.

It would still work and  be the same at 11,000 RPM.


Paul Lamar


I would most likely use the 2 per rotor system- I like redundancy.
:).

Do you have a schematic yet?

Kevin Alderman

No schematic. Trade secret. Fits in an aluminum box with heat sink 5"
by 2" by 1".

Paul Lamar

For your coil, why not use the rotor/ stator combo from a smallish
alternator? A normal car alternator uses coils wound to produce 3ph
AC. The output is controlled by varying the magnetic field. What if
you magnetized the rotor, dropped the shaft, and attached it to the
end of the crankshaft? The rotor pictured is for a Delco alternator
used in a windmill, and this one is a permanent magnet.

I haven't tried or tested it, but it the aim is lots of power, this
could be the way to do it similar to the CD ignition systems you
tried before. These alternators are on my boat- 32 V and 80 amp,
which would be the same as 12V and 240 amp. Its all AC, and should
be easily steppable up or down.

I am going to convert my boat to 24 volt since it is a real hassle to
find 32 volt lights, bilge pumps, etc, and to do that I will have to
remove the old alternators. They are kind of big for actual use, but
might prove good for testing, but It will be after the first of the
year before I can get to it. If anyone has an old alternator like off
of a japanese car that they want to send me for Christmas, I will put
it to good use!



Kevin Alderman

We are still researching the best coil to use.

Paul Lamar



Paul, Do you know how much you will be selling the ign units for
when ready, as I will be needing one. I could send the money for it
with the money for the gears. BTW did you find out from your wife if
an electronic transfer to her account is OK.----Chris.

I don't know yet. We have a lot of testing to do.

I can say there are only three wires. +12 volts, reluctance pick up
and coil positive. Not counting ground of course. Very easy to wire.

Paul Lamar



Hi Paul,

Can this ignition system be built for a three rotor. I will be puting
one in a Velocity in the not too distant future.

Mark Lewis


Yes.

Paul Lamar

-----------------------------------------------------------------------

Better picture of the spark. The spark messes with the auto focus in my camera.
I had to set it to manual focus.

Paul Lamar

-----------------------------------------------------------------------

Toyota, of all people, did some R&D on the Mazda 13B rotary in 1979. They found that adding
air injection to the exhaust port and a glow plug in the leading
spark plug hole reduced the fuel  burn 7% at low load low RPM. The
name of the game with cars. In the world of BSFC 7% is huge.

This is evidence we are on the right track with this new ignition.

I am putting it in small scale production now.


Paul Lamar

Paul, Any idea what effect (if any) there will be on spark plug life
??...............They are cheaper than gasoline
though............<:)

Kelly troyer

No idea. The number of sparks per rev can be changed simply by
changing the trigger wheel.

Paul Lamar


So the stock Mazda coils you told us to buy in the past are all
useless?
C. Smith

You can use them if you wish and you have a computer to fire them
at the right time.  You can also sell them on E-bay. Hardly useless.
Technology marches on. Last month's smart cell phone is now obsolete :)

In fact this ignition is made possible by recent developments in semi
conductors and switching power supply technology.

If you have some old oil filled can coils lying around this ignition will
work fine.

The new best coil to use with this ignition, according to our switching
power supply  guru Robert Leclercq, is the Mercury 2 cycle outboard coils.

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
You Tube http://tinyurl.com/beqqxas
Copyright 1998-2013 All world wide rights reserved.