Subject: ceramic rotor and housing
From: rotaryeng
Date: 12/29/2013, 12:17 PM
To: AAA-rotaryeng


Hi

I'm inventor at Korea.

As my calculation using ceramic rotor and housing make no cooling
system or extremely less cooling system.

In that case efficiency and power  get much better.

and I also considering using superalloy for that. like Inconel.

I need opinion of yours.


puru puru

It is worth a try.

Paul Lamar


   Hello everybody!: I guess that Mazda conducted some research on a similar concept, they
  called it: 'Adiabatic Wankel type Rotary Engine', SAE paper 860616 by R Kamo and R M Kakwani
   is about this.
  As the subject of improving ignition in Wankel RCEs came recently to this forum, I'd like
  adding some references that may have a connection to this, all SAE papers:

 920303: 'Heat transfer and performance characteristics of a Dual-Ignition Wankel Engine',
    M S Raju (Sverdrup Technology, Inc)

920304: '3-D Computations to improve combustion in a Stratified-Charge Rotary Engine
   Part III: Improved Ignition Strategies', J Abraham (John Deere) and F V Bracco (Princeton Univ)

930680: 'Catalytic Glow Plugs in the JDTI Stratified Charge Rotary Engine', Dylan Hixon et al (Precision Combustion Inc)
 2001-01-1844/4263: 'Research and Development of a Direct Injection Stratified Charge Rotary Engine with
  a Pilot Flame Ignition System', Takumi Muroki et al (Kanagawa Institute of Technology and Chiba University)

  It doesn't deal with the same, but the title of this SAE paper sounds good to me:
 860562: 'Experimental evaluation of Rotary Engine Timing Gear Loads', Mark R Kulina (John Deere)

 In the issue of rotor temperature affecting favorably several things: HC emissions, BSFC, perhaps the
  reduction in exhaust HC may allow to a fuel/air ratio more favorable for fuel economy; in China,
 professor Teluan Chen headed a large multi-centric research about RCEs, published in SAE paper 880628,
  one of the models proposed in the article as having good performance used a PP with a Reed-Valve control,
 directly sending the fuel:air mix towards the hot surface of Rotor, this helping in Vaporization of gasoline,
 Rotor cooling, and fuel economy and emissions results.

 Hope somebody finds an interest in this; if testing some of these ideas, tell us about results, please.
 Thanks for your attention. Nice year 2014.

          Salut †      Jose Gros-Aymerich
                          Madrid, Spain

Reed valves are not needed with side exhaust ports.
On peripheral intake port the airflow never really stops due to
the inertia of the air molecules so the reed valve would not function.
As the narrow apex passes over the intake p-port the next chamber in line starts
receiving air as the first chamber is closing.

Reed valves are obsolete   tech.

www.rotaryeng.net/Adiabatic-rotary.pdf‎

http://papers.sae.org/860616/

http://www.sbir.gov/sbirsearch/detail/72100

http://ceramicrotaryengines.com/

http://link.springer.com/chapter/10.1007%2F978-1-4757-9348-2_6#page-1

Paul Lamar


The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.