Subject: prop flange on hollow 2 inch prop shaft gear box
From: rotaryeng
Date: 1/27/2014, 11:29 PM
To: undisclosed-recipients:;



Use extended point 3/8-24 set screws 1/2 inch long.
Drill the flange and shaft together on a rotary table
six places with 1/4 inch drill. 12 places if you want to be conservative.

Then use a tap drill on the flange and tap.

This is much stronger than a spline or two 3/8th pins used by Ross.
Easier to get off for inspecting the gear box.

Note that the extended point set screws do not go all the way through the 1/4 wall prop
shaft. Only to about .1 inch deep. This retains a lot of  the prop shaft strength
in this area.  This is stronger than a spline.

With a P-port and a 3.12 to one gear ratio prop torque is 200 X 3.12
or 625 foot pounds. Therefor the shear load on the set screws is only
about 100 pounds each. 200 pounds peak each depending on the rubber
bushing coupling the engine to the sun gear. More if prop thrust
is added in.  Use 12 of these screws to be conservative.

Use the SAE #3 flange dimensions for wood and composite props.

If you go with a Warp Drive/Sensenich  style ground adjustably SAE #1
flange can be used.

For the P-port rotary you will need four Sensenich carbon blades.

Paul

 The Rotary Engine News Letter. Powered by Linux.
 ACRE NL web site. http://www.rotaryeng.net
 You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2013 All world wide rights reserved.