Subject: prop flange on hollow 2 inch prop shaft gear box
From: rotaryeng
Date: 1/28/2014, 3:11 PM
To: AAA-rotaryeng




Use extended point 3/8-24 set screws 1/2 inch long.
Drill the flange and shaft together on a rotary table six places with 1/4 inch drill. 12 places if you want to be conservative.

Then use a tap drill on the flange and tap.

This is much stronger than a spline or two 3/8th pins used by Ross.
Easier to get off for inspecting the gear box.

Note that the extended point set screws do not go all the way through the 1/4 wall prop shaft. Only to about .1 inch deep. This retains a lot of  the prop shaft strength in this area.  This is stronger than a spline.

With a P-port and a 3.12 to one gear ratio prop torque is 200 X 3.12 or 625 foot pounds. Therefor the shear load on the set screws is only about 100 pounds each. 200 pounds peak each depending on the rubber bushing coupling the engine to the sun gear. More if prop thrust is added in.  Use 12 of these screws to be conservative.

Use the SAE #3 flange dimensions for wood and composite props.

If you go with a Warp Drive/Sensenich  style ground adjustably SAE #1 flange can be used.

For the P-port rotary you will need four Sensenich carbon blades.

Paul

Paul,
            Good idea actually, finally understand what you are on about and simple.  What is the prop flange made of, alloy or steel??  Feel steel would be better with the retaining screws or am I dreaming as usual?? Neil.

4340 heat treated to rockwell 60 or so.

Paul Lamar

Hi Paul,
    Where do I find .250 wall 4340 X 2" tube ?
    Chris.


That is for the flange. 4340 bar stock. Have them cut off a 2 inch junk out of 6 inches OD.
I think your adjustable pitch prop can use an SAE #1 flange.

The 4130 tubing is for the prop shaft.

You can have it dropped ship to me and I will mail it to NZ
or have your airline pilot friend pick it up at SFO.

Paul Lamar

  The Rotary Engine News Letter. Powered by Linux.
  ACRE NL web site. http://www.rotaryeng.net
  You Tube http://tinyurl.com/beqqxas
  Copyright 1998-2013 All world wide rights reserved.