I took a look at the front of the RX8 engine and I would
have to take off a lot of stuff to get to the e-shaft and replace
the stock trigger wheel.
I decided to use a micro computer to sense the ignition pulse
of the stock RX8 EFI computer and add multi strike
capability. The stock RX8 system fires only once around 22 degrees
BTDC. My system is capable of firing ten times every ten degrees.
22 deg BTDC, 10 deg BTDC, TDC, 10 deg after, and 20 deg after etc.
etc. up to 160 degrees.
The micro computer will detect the stock firing and then
do the firing of my ignition system at the proper following times.
This will only work correctly at 3000 RPM which the cruising speed
on the freeway in 6th gear for 80 MPH. The 3000 RPM will be the red line
for this testing.
All this is easier than installing a new trigger wheel on the nose of
the e-shaft while the engine is still in the car.
I want a back to back fuel consumption test at a steady 80 MPH.
My ign system verses the stock ign system.
I am looking at Picaxe as it is programed in BASIC. I prefer
that over the Arduino modified C language. I am not fond of the
Arduino language. Pic BASIC has been around for over 20 years
as I recall.
http://www.picaxe.com/
These are cheap computers that are real easy to program.
About as easy as it gets. I'll use one per spark plug.
A 28X2 is about right. A bit over kill but real cheap.
Hardware interrupts are necessary and crucial and the picaxe has
them.
Interrupts and Multi-Tasking
*************************************************
setint ........... Set the input conditions which cause an interrupt
setintflags.... Specify the events which cause an interrupt
restart.......... Restart a program task
resume ........ Resume executing a suspended program task
suspend ....... Suspend a program task
I would also make a good fuel injection computer. One per injector.
Paul Lamar