Subject: testing my new ignition on my RX8
From: rotaryeng
Date: 1/29/2014, 7:01 AM
To: AAA-rotaryeng



I took a look at the front of the RX8 engine and I would have to
take off a lot of stuff to get to the e-shaft and replace the stock
trigger wheel.

I decided to use a micro computer to sense the ignition pulse of
the stock RX8  EFI computer and add multi strike capability. The
stock RX8 system fires only once around 22 degrees BTDC. My system
is capable of firing ten times every ten degrees.

22 deg BTDC, 10 deg BTDC, TDC, 10 deg  after, and 20 deg after etc.
etc.  up to 160 degrees.

The micro computer will detect the stock firing and then do the
firing of my ignition system at the proper following times.

This will only work correctly at 3000 RPM which the cruising speed
on the freeway in 6th gear for 80 MPH. The 3000 RPM will be the red
line for this testing.

All this is easier than installing a new trigger wheel on the nose of
the e-shaft while the engine is still in the car.

I want a back to back fuel consumption test at a steady 80 MPH. My
ign  system verses the stock ign system.

I am looking at Picaxe as it is programed in BASIC. I prefer that
over the Arduino modified C language. I am not fond of the Arduino
language. Pic BASIC has been around for over 20 years as I recall.

http://www.picaxe.com/

These are cheap computers that are real easy to program. About as
easy as it gets. I'll use one per spark plug.

A 28X2 is about right. A bit over kill but real cheap.

Hardware interrupts are necessary and crucial and the picaxe has
them.

Interrupts and Multi-Tasking
************************************************* setint ...........
Set the input conditions which cause an interrupt setintflags....
Specify the events which cause an interrupt restart..........
Restart a program task resume ........ Resume executing a suspended
program task suspend ....... Suspend a program task

I would also make a good fuel injection computer. One per injector.


Paul Lamar



uh oh Paul...

the RX-8 that I have and that I bought for my son both are geared for a
different engine rpm vs. speed set...  MINE is at 4K rpms at 80 mph.... at
3000 rpm, I'm actually spot on at 60 mph.   (6th gear)

Gary Buster
East Texas


I'll have to get mine out of the hangar and check again. Might be old age memory
on my part.  What MPG are you getting at a steady (cruise control) 65 MPH?
I am getting 25 MPG. Mine is a 2004.

Paul Lamar

The Rotary Engine News Letter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net.
You Tube http://tinyurl.com/beqqxas.
Copyright 1998-2013 All world wide rights reserved.